|
重庆晟码机电设备有限公司
联系：周海于18983831296
座机：023-67477668
邮箱：cqshengma@163.com
地址：重庆市渝北区宝圣大道1018号
|
|
|
| ThorX7 打标软件英文版安装说明 |
|
| 时间：2020-09-09 09:34:41 来源： 作者： |
|
|
Step 1 double click it.and open the file”ThorX7 Net.”
You will get three file.
Step 2 double click “TxSetup7.exe”
You will get below pic.
Step 3,input”D”,install the software to D dish.
Step 4,click “设置控制板链接方式”(Set control board link)，you will get below pic.
Step 5,choose “本地链接”，IT’s mean “Local link”.
Step6,choose”单机直连”，（Direct connection），then click “确定”，(Enter).
Step 7,install it.
Step8,click“No”.
Step9,the left side file”ThorX7” is the install file in our D disk Thorx7 install file bag. Right side file “ThorX7” we sent you with the software, it is English language file. Use it repalce the left side install file, then open softare from desktop.you will get English software.
Step 10,according it to open hardware parameter.
Step 10,input password:888888,and click “OK”
Step 11,choose motor drivers,then click “OK”
Step12,Change the IP address in IPv4 in network sharing. The original default IP address is  192.168.0.2. You can change it to  192.168.0.3. In short, you only need to change any number. The picture below guides you to find the IP address.
Now you can use it. 1,common letter and number.2,Curved text,3. dot marking,4,logo by other file.SLG or PLT file.5,usually is very good in this,becasue it is JPg pic. 6,drawing symbol.
重庆晟码机电设备有限公司 023-67477668 专业生产气动打标机、激光打标机、刻划机等数控自动化设备 |
上一篇：光纤激光自动柔性标牌打标机出口项目发货
下一篇：返回列表 |
|
